GE GXRV10ABL01 User Manual

Faucet Drain Tubing and Water Supply Tubing
Customer ServiceTroubleshooting Tips
Operating Instructions
Safety Instructions
Installation Instructions
If Option A, BASEMENT ACCESS INSTALLATION, see
Filtration Drain Connection Installations section, was used,
go to step 2.
If Option B, C or D from page 13 was used, connect
the faucet drain tubing by running the 27² length,
3⁄8²tubing from the 3⁄8²faucet barb to the drain fitting
(installed in Filtration Drain Connection Installations
section). Keep this tubing run as short and straight as
possible, without loops, dips, or low-spots. Cut the tubing
as needed and insert into the drain fitting (see Fig. 3B,
3C or 3D in the Filtration Drain Connection Installations
section).
To connect the water supply tubing: Run the 1⁄4²tubing
(marked “WATER SUPPLY”) from the Reverse Osmosis
inlet to the feed water supply fitting (see Fig. 2A or 2B,
in the Feed Water Supply section). Connect the tubing as
applies (Fig. 2A or 2B, in the Feed Water Supply section)
and tighten the nut securely (use Teflon Tape™ to
prevent leaks).
Apply the Filter replacement reminder label to one
of the filter sumps between the ribs. Mark the date for
filter replacement six months from the installation date.
3
2
1
15
Fig. 5.
3⁄8²
drain tubing
Drain line*
Water supply
valve or
compression
fitting
Hot Cold
Automatic shutoff assembly
Storage tank
*For drain line options see Reject Water Drain Fitting section.
RO inlet
Filter Replacement Reminder Label

GE GXRV10ABL01 Specifications

General

Brand	GE
Model	GXRV10ABL01
Category	Water Filtration Systems
Language	English