Installation Instructions
ITOI LEVEL THE RANGE {CONT.}
[]
On all warming drawer models, the rear
leveling legs must be adjusted prior to moving
the range into position. Theg can be adjusted
from the bottom at the back of the range.
Adjust from
the bottom back
of range
(warming drawer \"X\models)
Back of range
[] Use an open-end or adjustable wrench to
adjust the leveling legs until the range is level.
[] Replace the drawer or panel.
[] OPERATION CHECKLIST
Turn on one of the surface units to observe that
the element glows within 60 seconds. Turn the
unit offwhen glow is detected. If the glow is not
detected within the time limit, recheck the range
wiring connections. If change is required, retest
again. If no change is required, have building
wiring checked for proper connections and
voltage.
Check to make sure the Clock (on models so
equipped) displag is energized. If a series of
horizontal red lines appear in the displag,
disconnect power immediatelg. Recheck the
range wiring connections. If change is made
to connections, retest again. If no change is
required, have building wiring checked for proper
connections and voltage. It is recommended that
the clock be changed if the red lines appear.
Be sure all range controls are in the OFF position
before leaving the range.
I_1 FINAL INSTALLATION CHECKLIST
• Check to make sure the circuit breaker is closed
(RESET)or the circuit fuses are replaced.
• Be sure power is in service to the building.
• Note (on some models}: If the clock flashes "bAd"
and then "LinE" with a loud tone, the neutral
connection to the range is miswired. Check the
terminal block connections and/or house wiring
to correct.
• Check to be sure that all packing materials and
tape have been removed. This will include tape on
metal panel under control knobs (if applicable),
adhesive tape, wire ties, cardboard and protective
plastic. Failure to remove these materials could
result in damage to the appliance once the
appliance has been turned on and surfaces
have heated.
• Check to make sure that the rear leveling leg is
fullg inserted into the Anti-Tip bracket and that
the bracket is securelg installed.
41
To Next Page
Loading...
Need help?
General
