Installation Instructions
| ATTACH THE MOUNTING
IL,==========,_
PLATE TO THE WALL
!
Attach the plate to the wall using toggle bolts.
At least one wood screw must be used to attach
the plate to a wall stud.
[] Remove the toggle wings flom the bolts.
[]Insert the bolts into the mounting plate through
the holes designated to go into drywall and reatmch
the toggle wings to :5" onto each bolt.
To use toggle bolts:
Mounting
Plate
,,I,
SpacingforTogglesMore
-.-I+---i+,,--ThanWallThickness
I
iToggle Wings
<-Wall "_
BoltEnd
[]Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the robs on the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly
centered under the cabinet.
CAUTION: Be careflfl to avoid pinching fingers
between the back of the mounting plate and the wall.
[]Tighten all bolts. Pull the plate away from the wall
to help dghten the bolts.
q
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
• Read the insuuctions on the TOP (;ABINET
TEMPI ,ATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPIATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
I-_ ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST
_ Remove and that holds blower motor
save sciew
to microwave.
BlowerMotor
"_/f!.-- BlowerMotor
- "_'- Screw
[] Gareflflly the blower unit. The wirespull
otlt
will extend far enough to allow you to adjust the
blower unit.
EndB
EndA
16
To Next Page
Loading...
Need help?
General
