Installation Instructions
MOUNT THE MICROWAVE
OVEN (cont.)
[] Insert 2 self-aligning screws
through outer top cabinet
holes. Turn two flfll turns oil
each screw.
[] Tighten center
screw completely.
[] Tighten tile outer two screws to tile top of tile
microwave oven. (While tightening screws, hold
tile microwave oven in place against tile wall and
tile top cabinet.'
1400and1600Series
1800Series
I
[] Install grease filters. See tile Owner's Manual
packed with tile microwave.
iNSTALLiNG THE
CHARCOAL FILTER
%
On 1400 and 1600 Series models, remove screws
on flont of grille using a #1 Phillips screwdriveL
On 1800 Series models, remove screws on top
front of grille using a #2 Phillips screwdriver.
Open tile door.
Remove tile grille.
On 1400 and 1600 Series models, pull tile grille
suaight off:
On 1800 Series models, slide tile grille to tile left
and pull it suaight off.
Charcoal
_!_ Install the charcoal filtex. When propmly installed,
tile wire mesh of the filter should be visible from
the f}ont.
Replace the grille and the screws.
_ Close the door.
Insert mesh-side up
22
To Next Page
Loading...
Need help?
General
