Installation Instructions
I-_ ALIGNING THE WALL PLATE
CAUTION:
Wear gloves to avoid cutting
fingers on sharp edges.
HoleC Centerline
Notches
ooooooo
o oooooooo
/
AreaE
Drawa Vertical
LineonWall
._-_- from Centerof
TopCabinet
HoleD
Hole B
[]Draw a vertical line on the wall at the center of the
30" wide space.
[]Use the mounting plate as the template for the rear
wall. Place the mounting plato on the wall, making
sure that the robs are touching the bottom of the
cabinet or the level line drawn in Step C for cabinets
with front overhang. Line up the notch and centerline
on the bottom of the mounting plate to the centerline
on the wall.
[] While holding tim mounting plate with one hand,
draw circles on the wall at holes A, B, C and D
(see illusuation above/actual plate marked with
arrows). Four holes must be used for mounting.
NOTE: Holes C and D are inside area E. If neifller
C nor D is in a stud, find a stud somewhere in area E
and draw a fifth circle m line up with the stud. It is
important to use at least one wood screw mounted
firmly in a stud m support the weight of the microwave.
Set the mounting plate aside.
WARNING: ruskofelectricshock.Can
cause injury or death. Take care to not drill into electrical
wiring inside walls or cabinets.
[] Drill holes on die circles. If there is a stud, drill a :X_"
hole for wood screws. For holes that don't line up with
a stud, drill a %" hole for toggle bolts.
NOTE: DO NOT MOUNT THE PLATE AT THIS
TIME.
10
To Next Page
Loading...
Need help?
General
