Installation Instructions
OUTSIDE TOP EXHAUST (Vertical Duct)
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Check Damper Operation
A4. Mount Microwave Oven
A5. Adjust Exhaust Adaptor
A6. Gonnect Ductwork
|
I-_ ATrACH THE MOUNTING
PLATE TO THE WALL
II
===m
Attach tim plate to tim wall using toggle bolts.
At least one wood screw illust be used to attach
the plate to a wall stud.
[]Remove the toggle wings flom the bolts.
[]Insert the bolts into the mounting plate
through the holes designated to go into drDvall
and reatmch the toggle wings to :_" onto each bolt.
12
To use toggle bolts:
Spacingfor Toggles
MoreThanWall
_,-_[_Thickness
ToggleWings
Mounting
Plate
BoltEnd
_ Place tim mounting plate against tim wall and
insert tim toggle wings into tim holes in tim wall
to i_lotlnt the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure tim robs on the mounting plate
touch the bottom of the cabinet when pushed
flush against the wall and that the plate is properly
centered under the cabinet.
A
• lkCAUTION: Be careful to avoid
pinching fingers between the back of the mounting
plate and the wall.
_ Tighten all bolts. Pull the plate away flom the wall
to help tighten tim bolts.
To Next Page
Loading...
Need help?
General
