GE LOGIQ F SERIES
D
IRECTION 5273008-100, REVISION 10 BASIC SERVICE MANUAL
Chapter 3 System Setup 3 - 5
Section 3-3
Receiving and Unpacking the Equipment
When a new system arrives, check that any components are not damaged and are not in short supply.
If shipping damage or shortage occurs, contact the address shown in Chapter 1.
Unpacking the the equipment
1.) Tear off the "stop open" mark.
2.) Cut off the two packing straps around the crate.
NOTE: To avoid injury, hold the strap clasp with one hand when cutting the strap.
3.) Remove the top cover.
4.) Remove the three plastic locks.
NOTE: Rotate the inside plastic lock counterclockwise to remove it and then remove the outside lock.
5.) Remove the outside shipping box.
6.) Remove the clear plastic (wrapped around the system) and aluminum foil bag from the unit.
NOTE: There is no clear plastic if the system is transported by sea. Ignore this step if there is no clear
plastic.
NOTE: To avoid damaging the unit, please use a pair of scissors instead of the knife.
7.) Unlock the strap.
8.) Remove the foams beside the LCD monitor and the front wheels.
9.) Unlock the wheels, and then hold the control panel at the front side to move the system until
the two front wheels are on the ground.
10.)With one hand holding the control panel and the other hand holding the rear handle, move the
whole system down to the ground.
11.)Remove all the covers and foams from the unit.
CAUTION
Do not lift the unit by the Keyboard. Equipment damage may result.
CAUTION
The crate with the LOGIQ F Series weighs approximately 75kg. Be prepared for a sudden shift
of weight as the unit is removed from its base (pallet)
To Next Page
Loading...
Need help?
General
