GE HEALTHCARE PROPRIETARY TO GE
D
IRECTION 5394227, 12 LOGIQ S8/LOGIQ E8 SERVICE MANUAL
4 - 6 Section 4-3 - General procedures
4-3-4 Complete shutdown
NOTE: The mains outlet of the system for peripheral auxiliary equipment are commonly switched with the power
button. So the auxiliary equipment need not to be switched ON/OFF separately.
1.) Enter the scan screen and lightly press the Power On/Off switch once. The System-Exit window is
displayed.
2.) Select Shutdown. The system performs an automatic full shutdown sequence.
3.) Switch OFF the Circuit breaker on the rear panel of the system.
4.) After complete power down, disconnect the main power cable from the system or unplug it from the
AC wall outlet socket.
NOTICE
!! NOTICE:
After turning off the system, wait at least 10 seconds before turning it on again.
The system may not be able to boot if power is recycled too quickly.
NOTICE
The
The system will go to Power Assistant Mode (Optional, R2 or later) if above procedures are skipped.
NOTICE
Be sure to wait with the next step until the system has finished its shut-down. Failing to do so may
destroy data on the Hard Disk Drive, making the system fail later.
WARNINGWARNING
Confirmation of LED status is necessary when repairing the system.
Confirm the Power Status LEDs are OFF.
- If the LEDs are turned ON, attempt to shut down the system again.
- If unable to turn off the system, press and hold the Power on/off button to force shutdown.
NOTE: For R4 or later system with Extended Battery option, the extended battery is charged when the
LOGIQ S8 in Standby-mode. While battery charging, LED is blinking and main fan is operating. But you
can turn off the circuit breaker and disconnect the power cable when the battery is charging.
Power Status LED
To Next Page
Loading...
Need help?
General
