10
CHANGING USER CODES
Step 1 Your system must be in the Disarmed state to change user codes.
Step 2 Press [r]-[5].
Step 3 Enter a “Master Arm/Disarm Code”.
Step 4 The ready light will flash.
Step 5 Enter the 2-digit “user number” (always enter 2 digits such as [0] - [3]
for user 3).
Step 6 Enter the new four (4) or six (6) digit “user code”.
NOTE: To delete a user code, enter [r]-[r]-[r]-[r] for a 4-digit code,
or [r]-[r]-[r]-[r]-[r]-[r] for a 6-digit code.
Step 7 The ready light will flash indicating you are back at Step 4 above. If
the code is rejected, the sounder will beep 3 times.
Step 8 If another “user code” needs to be programmed, return to Step 5.
Step 9 Press the [#] key while the ready light is flashing to exit the User
Code Programming Mode.
ASSIGNING USER CODE AUTHORITY LEVELS
Assign authority levels to users by following the steps below. Assign user codes
before assigning authority levels.
Step 1 Press [r]-[6].
Step 2 Enter a “Master Arm/Disarm Code”.
Step 3 The ready light will flash.
Step 4 Enter the 2 digit “user number” to be assigned authority (always 2
digits such as 03 for user 3). The ready light is constant and the
instant light will flash.
Step 5 Lights illuminated indicate the authority levels assigned to this code.
An explanation of the lights is listed below. You may toggle (turn
on/off) the authority level by pressing the number for that authority
level.
To Next Page
Loading...
Need help?
General
