NX1448E Icon Keypad Page 11
UNDERSTANDING THE ICONS & LIGHTS
ARMED ICON
The armed icon is “on” when the system is armed. The armed icon is
“off” when it is disarmed. The armed icon will flash when there has
been an alarm during the previous arm cycle.
BYPASS LIGHT
The bypass light is “on” when any zone in this keypad’s partition is
bypassed. The zone(s) that is bypassed will also be illuminated. If the
bypass light is “off”, no zones are bypassed.
CANCEL LIGHT
The cancel light will flash during an abort delay time. If a code is
entered followed by the [CANCEL] key while this light is flashing, all
abortable reports will stop the communication process. Note: The abort
feature must be enabled. Entering a code followed by the [CANCEL]
key during or after an alarm report to the central station will cause the
cancel light to come on. It will stay on until the central station has
received the cancel report. Note: The cancel feature must be
enabled.
CHIME LIGHT
The chime light is “on” when the chime feature is “on”; “off” otherwise.
EXIT LIGHT
The exit light is “on” during the exit delay. Please note that the light will
flash during the last 10 seconds of the exit delay as a warning that the
time is running out. (The user may want to disarm the system if the
exit light is flashing in order to prevent an alarm. The user may then re-
arm the system and exit before the delay expires.)
FIRE ICON
A steady fire icon means a fire zone has been faulted. A rapidly flashing
fire icon means that a fire zone is in a trouble condition.
To Next Page
Loading...
Need help?
General