Page 14 NX1448E Icon Keypad
ARMING YOUR SYSTEM IN THE “STAY” MODE
STAY is used when the user is inside the premise and wants protection
around the perimeter.
Close all protected doors and windows. Step 1
• Ready icon must be on or flashing when all protected zones and
sensors are secure. NOTE
: If any zones are bypassed, a sensor in
that zone can be violated without affecting the ready icon.
• The security system will not arm if the not ready icon is on or
flashing.
• If the power icon is off, you have no AC power. Restore power if
possible. If not, contact your installing company listed on page 1
of this booklet for service.
Step 2 • Enter your 4 or 6 digit user code.
• If “Auto Bypass” is enabled, all interior zones will be bypassed if
you do not leave through a designated entry/exit door. If Auto
Bypass is enabled, omit Step 3.
• When “Auto Instant” is enabled, if you do not leave through a
designated entry/exit door the instant icon will illuminate
indicating that the entry/exit doors no longer have an entry delay.
If “Auto Instant” is enabled, omit Step 4.
Step 3 • Press the [STAY] key.
• The stay light will illuminate indicating that all interior zones are
bypassed. (All interior devices will bypass automatically, giving
the user freedom of movement within the interior area.)
• The bypass light will illuminate if any zone(s) are bypassed. If any
zone(s) have been bypassed previously by the user, the icon(s)
corresponding to the bypassed zone(s) will illuminate, alerting the
user that a zone(s) may be unprotected and can be faulted
without an alarm.
To Next Page
Loading...
Need help?
General