EasyManuals Logo
Home>GE>Ranges>Profile P2S975DEP

GE Profile P2S975DEP Installation Instructions

GE Profile P2S975DEP
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
TOOLS YOU WILL NEED
• 1/4” Nut Driver • Level • Pipe Wrench
• Tape Measure • Drill Safety Glasses
• Phillips Head Flat Head Wrench or Pliers
Screwdriver Screwdriver (for 1 7/16” Nut)
1
MATERIALS YOU MAY NEED
31-10641-3 03-09 JR
Printed in the United States
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.com
In Canada, call 1.800.561.3344 or Visit our Website at: www.GEAppliances.ca
Installation
Self-Cleaning Dual Fuel
Instructions
Slide-In Range
P2S975
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
IMPORTANT Save these
instructions for local inspector’s use.
IMPORTANT Observe all
governing codes and ordinances.
Note to Installer – Be sure to leave these
instructions with the Consumer.
Note to Consumer – Keep these
instructions for future reference.
Product failure due to improper installation
is not covered under the Warranty.
WARNING This appliance must
be properly grounded.
Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
WARNING
Before beginning
the installation, switch power off at service
panel and lock the service disconnecting means
to prevent power from being switched on
accidentally. When the service disconnecting
means cannot be locked, securely fasten
a prominent warning device, such as a tag,
to the service panel.
IN THE COMMONWEALTH OF
MASSACHUSETTS:
This product must be installed by
a licensed plumber or gas fitter.
When using ball-type gas shut-off valves,
they shall be the T-handle type.
A flexible gas connector, when used,
must not exceed 3 feet.
PARTS INCLUDED
Anchor SleevesLag Bolts
(For Concrete Floors Only)
Shut Off Valve
Pipe Fittings
CSA-Approved Flexible Gas Line
3/8 Min. ID, 1/2 NPT Connection,
3-foot Maximum Length (Massachusetts only)
Joint Sealant
Screws
Rear Filler
2 Screws
FOR YOUR SAFETY
If you did not receive an anti-tip bracket with your
purchase, call 1.800.626.8774 to receive one at no cost.
(In Canada, call 1.800.561.3344.)
For installation instructions of the bracket, visit:
GEAppliances.com. (In Canada, www.GEAppliances.ca.)
Anti-Tip Bracket
Kit Included

Other manuals for GE Profile P2S975DEP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE Profile P2S975DEP and is the answer not in the manual?

GE Profile P2S975DEP Specifications

General IconGeneral
BrandGE
ModelProfile P2S975DEP
CategoryRanges
LanguageEnglish

Related product manuals