GE Profile P2S975DEP Installation Instructions

7
Installation Instructions
ELECTRICAL CONNECTIONS
The range is shipped with a 4-
wire power cord. If your outlet
looks like the one shown, skip to
step 19 and proceed.
POWER CORD AND STRAIN
RELIEF INSTALLATION
Remove the wire
cover (on the back
of the range) by
removing 2
screws, using a
1/4″ nut driver.
Do not discard
these screws.
Remove the knockout ring (1-3/8″)
located on bracket directly below the
terminal block. To remove the knockout,
use a pair of pliers to bend the knockout
ring away from the bracket and twist
until ring is removed.
B
A
11
For power cord installations only (see the
next step if using conduit), assemble the
strain relief in the hole. Insert the power
cord through the strain relief and tighten.
Allow enough slack to easily attach the
cord terminals to the terminal block. If
tabs are present at the end of the winged
strain relief, they can be removed for
better fit.
NOTE: Do not install the power cord
without a strain relief. The strain relief
bracket should be installed before
reinstalling the rear range wiring cover.
For conduit installations only, purchase
a squeeze connector matching the
diameter of your conduit and assemble
it in the hole. Insert the conduit through
the squeeze connector and tighten. Allow
enough slack to easily attach the wires to
the terminal block.
NOTE: Do not install the conduit without
a squeeze connector. The squeeze
connector should be installed before
reinstalling the rear range wiring cover.
D
C
Wire Cover
Terminal block
(appearance
may vary)
Knockout
ring removed
Knockout ring
in bracket
Terminal
block
Bracket
Terminal
block
Strain relief
Power cord
Bracket
Squeeze
connector
Conduit
NEMA 14-50R
4-wire

GE Profile P2S975DEP Specifications

General

Brand	GE
Model	Profile P2S975DEP
Category	Ranges
Language	English