To Next Page

To Previous Page

Installation Instructions

EXHAUST CONNECTION

LEVEL

SIDE-TO-SIDE.

2 LEVELING LEGS

LEVEL

FRONT-TO-BACK.

DUCT TAPE OR

DUCT CLAMP

DUCT TAPE OR

DUCT CLAMP

4" METAL DUCT CUT

TO PROPER LENGTH

EXTERNAL DUCT

OPENING

For straight line installation, connect

the dryer exhaust to the external

exhaust hood using duct tape or

clamp.

LEVELING AND STABILIZING YOUR APPLIANCE

STANDARD REAR EXHAUST

Level and stabilizing your appliance

&DUHIXOO\PRYHWKHDSSOLDQFHWRLWV¿QDOORFDWLRQ*HQWO\URFN

the appliance into position. It is important not to damage the

UXEEHUOHYHOLQJOHJVZKHQPRYLQJ\RXUDSSOLDQFHWRLWV¿QDO

location. Damaged legs can increase appliance vibration. It

PD\EHKHOSIXOWRVSUD\ZLQGRZFOHDQHURQWKHÀRRUWRKHOS

PRYH\RXUDSSOLDQFHWRLWV¿QDOSRVLWLRQ

Note: Do not use washer cover to lift the unit.

2. To ensure the appliance is level and solid on all four legs,

WLOW WKH DSSOLDQFH IRUZDUG VR WKH UHDU OHJV DUH RȺ WKH

ground. Gently set the appliance back down to allow the

rear legs to self adjust.

:LWKWKHDSSOLDQFHLQLWV¿QDOSRVLWLRQSODFHDOHYHORQWRS

of back part of the washer lid and check it side to side,

then check front to back. Screw the front leveling legs up

or down to ensure the appliance is resting solid on all four

OHJV QR URFNLQJ RU WKH DSSOLDQFH VKRXOG H[LVW WXUQ WKH

lock nuts on each leg up toward the base of the unit and

snug with a wrench.

Note: Keep the leg extension at minimum to prevent excessive

vibration. The farther out legs are extended, the more the unit

will vibrate.

STANDARD REAR EXHAUST

9HQWHGDERYHÀRRUOHYHO

(/%2:+,*+/<

RECOMMENDED

CONFIGURATION

TO MINIMIZE

(;+$867%/2&.$*(

NOTE: ELBOWS WILL PREVENT DUCT KINKING AND COLLAPSING

WARNING - TO REDUCE THE

RISK OF FIRE OR PERSONAL INJURY:

• This appliance must be exhausted to the outdoors.

• Use only 4” rigid metal ducting for the home exhaust

duct.

 8VH RQO\ µ ULJLG PHWDO RU 8/OLVWHG ÀH[LEOH PHWDO

VHPLULJLGRUIRLOW\SHGXFWWRFRQQHFWWKHGU\HUWRWKH

home exhaust duct. It must be installed in accordance

with the instructions found in “Connecting The Dryer

To House Vent” on page 8 of this manual.

• Do not terminate exhaust in a chimney, a wall, a ceiling,

JDVYHQW FUDZOVSDFHDWWLF XQGHUDQ HQFORVHGÀRRU

or in any other concealed space of a building. The

accumulated lint could create a

potential¿UHKD]DUG

• Never terminate the exhaust into a common duct with

a kitchen exhaust system. A combination of grease

DQGOLQWFUHDWHVDSRWHQWLDO¿UHKD]DUG

 'RQRWXVHGXFWORQJHUWKDQVSHFL¿HGLQWKHH[KDXVW

length table. Longer ducts can accumulate lint,

FUHDWLQJDSRWHQWLDO¿UHKD]DUG

• Never install a screen in or over the exhaust duct. This

ZLOOFDXVHOLQWWRDFFXPXODWHFUHDWLQJDSRWHQWLDO¿UH

KD]DUG

• Do not assemble ductwork with any fasteners that

extend into the duct. These fasteners can accumulate

OLQWFUHDWLQJDSRWHQWLDO¿UHKD]DUG

• Do not obstruct incoming or exhausted air.

•

Provide an access for inspection and cleaning of the exhaust

system, especially at turns and joints. Exhaust system shall

be inspected and cleaned at least once a year.

THIS DRYER COMES READY FOR REAR

EXHAUSTING. IF SPACE IS LIMITED, USE

THE INSTRUCTIONS IN SECTION 6 TO

EXHAUST DIRECTLY FROM THE SIDES OR

BOTTOM OF THE CABINET.

Brand	GE
Model	Unitized Electric Washer/Dryer
Category	Washer/Dryer
Language	English

GE Unitized Electric Washer/Dryer User Manual

Table of Contents

Questions and Answers:

GE Unitized Electric Washer/Dryer Specifications

Related product manuals