– 29 –
Tub Cover
Note: The tub cover can be replaced without
removing the tub.
To remove the tub cover:
Remove the front panel. (See 1. Front Panel.)
Remove the cover/lid assembly. (See 2.
Cover/Lid
Assembly.
)
Disconnect 4 dampening straps from the tub 3.
cover by removing four 5/16-in. hex-head
screws.
Release the cover from the outer tub by lifting 4.
the 8 tabs.
Raise the front of the cover to clear the front 5.
cabinet brace and tilt the tub forward.
Carefully lift and remove the cover from the tub.6.
Tub Cover
Tub Assembly
Note: The motor can be replaced without removing
the tub. (See Inverter/Motor.) The tub assembly must
be removed when replacing the spin basket, outer
tub, or certain speed drive components.
To remove the tub assembly:
Disconnect power.1.
Lower the drain hose into a small bucket to 2.
remove any water remaining in the tub.
Remove the front panel. (See 3. Front Panel.)
Remove the cover/lid assembly. (See 4. Cover/Lid
Assembly.)
Remove the tub cover. (See 5. Tub Cover.)
Remove the infusor. (See 6. Infusor.)
Pull the drive coupling straight up from the 7.
infusor shaft.
(Continued next page)
Tab (1 of 8)
Drive Coupling
To Next Page
Loading...
Need help?
General
