– 15 –
Washer Components
WARNING: Sharp edges may be exposed when
servicing. Use caution to avoid injury. Wear Kevlar
gloves or equivalent protection.
Shipping Rod
There is a new location for the shipping rod. The rod
is inserted and removed through a hole located on
the lower right side of the cabinet and now passes
in front of the drain pump.
The shipping rod passes through the chassis rod
brackets and the platform brackets.
Leveling Legs
The front legs are screw type and are adjusted
by turning the legs counterclockwise to increase
height. The rear leveling legs are contained in an
assembly and will level the rear of the washer left to
right.
To level the washer, tilt the washer forward to lift the
rear legs off the fl oor, then gently set it back down.
Adjust the front leveling legs to level the washer
front to back and left to right across the front.
Infusor
The infusor is attached to the top of the infusor
drive coupling with a 7/16-in. hex-head bolt. It is
necessary to remove the fabric softener dispenser
to access the hex-head bolt.
Rod Inlet Hole
Shipping Rod
(Continued next page)
Infusor
Fabric Softener
Dispenser
Chassis Rod
Bracket
Chassis Rod
Bracket
Platform Brackets
To Next Page
Loading...
Need help?
General
