59
OPERATION
Starting and Stopping the Engine
Before Starting the Engine
1. Adjust the seat for a comfortable operating
position.
2. Fasten the seat belt.
3. Check that the safety bar is in the locked
position.
4. Check that the control levers and pedals
are in the neutral position.
5. Insert the key into the starter switch, turn
it to the ON position, then perform the
following inspection:
¡All the warning lamps flash and an
alarm is sounded for 2 seconds. The
meters also start functioning. After 2
seconds, only the battery charge
warning lamp (4) and engine oil
pressure/coolant level warning lamp (2)
flash, and the other lamps turn off.
¡Turn the light switch to check that the
front light, tail lights and meter light turn
on.
¡Check the fuel level.
If a lamp does not light or the alarm is not
sounded, the bulb may be burnt out or a wire
may be damaged. Contact a Gehl sales or
service outlet for repairs.
T7B015
N
N
B
A
T7D002
PREHEAT
OFF
ON
START
E4D002
T7D0031
4
2
To Next Page
Loading...
Need help?
General
