geminox THR 10-100 Series User Manual


23(5$7,1*)$8/76
  'LVSOD\RIIDXOWV
%HQHILWV
- Simple control of the installation.
- Fault search tool
'HVFULSWLRQ The controller displays faults that may have occurred in the regulator itself or in the
system. In normal operation, the display shows "Er" if a fault has occurred.
6HWWLQJ
- Press the line selection buttons to select programming line 50.
- Press the plus / minus buttons to display the list of faults.
(IIHFW The first entry in the fault list will automatically be displayed on this programming line.
Note:
- By pressing , it is possible to switch between error message signals.
)DXOWVWDWXV
VLJQDOV
The regulator can store a maximum of two error message signals. The errors will be
cleared only after the cause of the fault has been removed. If additional faults are
present, they will be memorized when memory capacity becomes available.
)DXOWVWKDWPD\RFFXUORFDOO\RQWKLVGHYLFH
- Note:
In the case of error code 150, operating line 49 also gives the manufacturer-specific
error code of the BMU.
'LVSOD\UDQJH 8QLW
0...255 -
'LVSOD\ 'HVFULSWLRQRIIDXOW
Blank No fault
10 Outside sensor
26 Cascade flow temperature sensor
46 Cascade return temperature sensor
50 D.h.w. temperature sensor
58 D.h.w. control thermostat
61 Room unit fault
62 Wrong room unit
70 Buffer storage tank temperature sensor
81 Short-circuit LPB
82 Address collision on LPB (several times the same address)
86 Short-circuit PPS
100 Two master clocks present
145 Non compatible device connected to PPS
146 Unacceptable installation configuration
147 No BMU/boiler connected
150 General BMU/boiler fault

geminox THR 10-100 Series Specifications

General

Brand	geminox
Model	THR 10-100 Series
Category	Boiler
Language	English