EasyManuals Logo
Home>geminox>Boiler>THR 10-100 Series

geminox THR 10-100 Series User Manual

geminox THR 10-100 Series
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #87 background imageLoading...
Page #87 background image

23(5$7,1*)$8/76
59$23(5$7,1*)$8/76
2QFHWKHIDXOWKDVEHHQHOLPLQDWHGWKH
(UHUURUPHVVDJH RQWKH59$PD\
WDNHWR PLQXWHVWRGLVDSSHDUDF
FRUGLQJWRWKHW\SHRIIDXOW
 2SHUDWLQJIDXOWV
+HDWLQJ FRQWURO GRHV QRW RSHUDWH ZURQJ RU
DEVHQWGLVSOD\RIWKHWLPH
Check the heating circuits fuses.
Carry out a RESET: isolate the regulator from
the mains for about 5 seconds (by positioning
the boilers main switch on stop for 5 seconds
for example).
Set the clock.
7KHVHWWLQJGHYLFHGRHVQRWRSHQFORVHRUDW
OHDVWQRWSURSHUO\
The manual lever of the setting device may not
be disengaged.
Wiring to the setting device interrupted (output
test).
Check the wiring of the sensor (input test).
Daily heating active or limit rapid lowering acti-
ve.
7KH KHDWLQJ FLUFXLW¶V FLUFXODWLQJ SXPS GRHV
QRWRSHUDWH
Check the wiring and the fuses (relay test).
Check the wiring of the sensors (input test).
7KHURRPWHPSHUDWXUHLVQRWFRUUHFW
Check the room temperature setting values.
Is the desired regime displayed?
Was an exception made to the automatic regi-
me on the room unit?
Do the displayed weekday, time and heating
programme coincide?
7KH KHDWLQJ LQVWDOODWLRQ GRHV QRW RSHUDWH
SURSHUO\
Check all the parameters according to the
"Heating Engineer" parameters and the "End-
user" service instructions.
Test the relays.
Test the inputs.
Check the control thermostat (TR) and the sa-
fety thermostat (STB).
7KH IURVWSURWHFWLRQ RI WKH LQVWDOODWLRQ GRHV
QRWRSHUDWHRUQRWSURSHUO\
Check the correct operation of the burner.
For the heating circuits with a circulating pump,
does the room temperature limiting function
have priority over the frost protection function?
7KH DFFHOHUDWHG WHPSHUDWXUH ORZHULQJ RU
ZDUPXSGRQRWRSHUDWH
Check the "Heating Engineer" level settings.
Check the sensor connected to A6 (input test).
7KH(5IDXOWPHVVDJHDSSHDUV RQWKHGLV
SOD\
Check that the LGMs Summer/Winter potenti-
ometer is on the Winter position.
Select programming lines 50, 60 and 62. Both
the error code and the address where the error
occured are displayed there. Paragraph 3.2 -
below lists the possible error codes and their
meaning.
The displays of these parameters must be
those of the following table.
!
59$UHJXODWRUSDUDPHWHUV 'LVSOD\
: display of the BMUs error
codes (LGM)
blank
: error display
blank
:
display of PPS communication
if room sensor on RVA 46
- - -
or
1 83

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the geminox THR 10-100 Series and is the answer not in the manual?

geminox THR 10-100 Series Specifications

General IconGeneral
Brandgeminox
ModelTHR 10-100 Series
CategoryBoiler
LanguageEnglish

Related product manuals