GiBiDi SC230 User Manual

Dichiarazione di conformità CE
Il fabbricante:
Gi.Bi.Di. Continental S.p.A.
Sede Legale
Sede Amministrativa-Ufficio Commerciale-Stabilimento :
Via Abetone Brennero, 177/B, 46025 Poggio Rusco (Mantova) ITALY
Tel. 0039 0386 522011 - Fax Uff.comm 0039 0386 522031
Dichiara che i prodotti:
Sono conformi alle seguenti Direttive CEE:
•Direttiva Bassa Tensione 73/23 e successive modifiche;
•Direttiva Compatibilità Elettromagnetica 89/336 e successive modifiche;
•Direttiva
e che sono state applicate le seguenti norme armonizzate:
Data 18/04/07
Firma Ammistratore Delegato
Oliviero Arosio
APPARECCHIATURA ELETTRONICA SC230
R&TTE 99/05
! EN60335-1, EN300 220-3, EN301 489-1, EN301 489-3
! EN61000-3-2, EN61000-3-3, EN61000-6-3, EN61000-6-1
SC2308
I
TECHNICAL SPECIFICATIONS
•Red warning LEDs of N.C. contacts (photocell, safety device, closing limit switch, opening limit switch, stop).
•Green warning LEDs of N.O. contacts (start and ped).
•Buttons START and PED on board.
•Safety test runs before the opening and closing movements.
•Deceleration during opening and closing controlled by 2 additional magnets to be assembled in the desired
position at a minimum relative distance of at least 500 mm. Deceleration is adjustable with a trimmer (SLOW).
•Stop and motion inversion for 2 seconds after intervention of the safety devices. At the next Star t pulse the motion
restarts in the obstacle freeing direction.
•Possibility of reading the motor rpm for the anti-crushing function by means of a sensor, both during normal
operation and in slow motion. The intervention of the sensor determines stopping and inversion of the motion for 2
seconds. At the next Start pulse the motion restar ts in the obstacle freeing direction.
•Pedestrian operation with fixed opening of 10 seconds. The automatic function and automatic closing are always
enabled.
•SAFETY DEVICE POWER SUPPLY. Connection to this power supply allows TESTING the devices before motion.
The safety devices must be connected to this terminal and will be powered only during the operating cycle.
FEATURES / FUNCTIONS
UK
SC230
9
Control unit SC230
Type
Electronic control unit for automation of a sliding gate with 230
VAC motor
Power supply 230VAC, single-phase, 50/60 Hz
No. of motors 1
Motor power supply 230 VAC
Flashlight 230 VAC 40W max
Warning light 24 VAC 3W max
Accessory power supply 24 VAC 8W max including safety device power supply
Safety device power supply 24 VAC 8W max including accessory power supply
Radio-receiver Plug-in
Operating temperature -20°C +60°C
Working time 240 s fixed
Pause time Adjustable between 2 and 215 s

GiBiDi SC230 Specifications

General

Brand	GiBiDi
Model	SC230
Category	Control Unit
Language	English