Pre-set programs 31
Code 429159
Rev. 15/0717
5.2. Interpreting the icons in tables of pre-set programs
The pre-set programs only use the functions available in the basic configuration of the washing machine without
additional options.
To interpret the functions numerical values, refer to the programming values indicated on chapter 7.3. of this
manual.
Approximate time of the program in minutes.
Water supply pressure: recommended values.
These times do not include the times for heating and cooling the bath.
Water inlet
The numerical value indicates the programmed water inlet.
Bath level
The numerical value indicates the level programmed.
Temperature in centigrade. Temperature value of the wash phase is highlighted.
The numerical value indicates the temperature programmed.
Temperature in Fahrenheit. Temperature value of the wash phase is highlighted.
The numerical value indicates the temperature programmed.
Dosing. Pre-set programs only use the internal dosing.
The numerical value indicates the dosing programmed.
Rotation
The numerical value indicates the rotation sequence programmed.
Rotation time
The numerical value indicates the rotation time in minutes.
Gradual cooling
Interprets the numerical value programmed: 0 = NO cooling 1 = YES cooling
Draining
Interprets the numerical value programmed: 0 = NO draining 1 = YES draining
Rotation speed during draining
The numerical value indicates the rotation speed programmed.
Draining / spin cycle time
The numerical value indicates the draining time in minutes.
Other icons used on the viewing screens of the wash programs
Buzzer at the end of the phase
No buzzer at the end of the phase
To Next Page
Loading...
Need help?
General
