GIRBAU EH040 User Manual

Programming a new wash program 44
Code 429159
Rev. 15/0717
There are six programmable speeds during draining.
The speeds 4, 5 and 6 are modifiable in the CONFIGURATION menu.
7.3.16. Spin time
Programming this function is only possible if drain and rotation speed 2 or higher has been programmed.
Important!
Unlike other Girbau washer controls, INTELI control spin time countdown starts when the positioning
speed has been reached and the unbalance value is correct.
Programming the spin time in minutes (default option)
Programmable time range: 1–15 minutes
Value by default: depending on programmed spin cycle
Programming the spin time in seconds (optional programming)
INTELI control allows you to change the unit of time for spinning to be programmed in seconds. This function
only appears if EXTRACT TIME UNIT sec has been activated in the SETUP menu. This option is available on
models with microprocessor Version 21D/21F or later.
ATTENTION!! If changes in the unit of time are made in the settings, or programs from a card are used
with different units of time to those of the machine, spin times may suffer alterations.
Possible programming
Rotation speeds in rpm
HS-6013
EH030
HS-6017
EH040
HS-6023
EH055
HS-6024
EH060
HS-6032
EH080
HS-6040
EH090
HS-6057
EH130
HS-6110
EH225
Drain without
drum rotation
Without rotation
Drain
<<< Option
programme
d by default
E1
Rotation sequence and washing speed programmed in wash
phase. Draining time non programmable
Drain +
positioning
speed
E2
100
100
87
86
83
79
72
66
Drain +
low spin
speed
E3
400
375
330
350
335
325
300
250
Drain +
medium spin
speed
E4
600
570
525
550
530
490
450
405
Drain +
medium/high
spin speed
E5
800
750
725
725
698
680
625
565
Drain +
high spin
speed
E6
1000
950
920
966
931
870
800
725

GIRBAU EH040 Specifications

General

Brand	GIRBAU
Model	EH040
Category	Washer
Language	English