GIRBAU EM040 User Manual

Cod. 429266
Rev. 01/0206
Operation
16
2.7 Stop modes
2.7.1 End of cycle
The buzzer and the LED indicating the end of the cycle inform that the program has finished and the door lock
is released.
2.7.2 Interrupting a program
A. Key
S
TART
/S
T
O
P
. Interrupting a washing program. STOP appears on the display. At the end of the safety
delay, the buzzer and the LED indicating the end of cycle inform that the program has finished and the
door lock is released.
B. Emergency stop
.
(except MS-610 / EM025, HS-6008 / EH020 models)
Pressing once on the EMERGENCY switch interrupts the washer operation and opens the drain valve.
ALM/EMER appears on the display.
After a delay of approximately 3 minutes, the door is released.
To resume the wash cycle, release the switch and press ONCE the key
S
TART
/S
T
O
P
.
To cancel the wash cycle, release the switch and press TWICE the key
S
TART
/S
T
O
P
.
C. Other stop modes are:
• Disconnecting the ON/OFF switch.
• Disconnecting the external automatic switch.
We do not recommend these stop modes, except in an emergency. In these cases, as long as the door
remains closed, the machine will understand that there has been a power failure. When the power is
switched back on, the machine will resume the program in progress.
D. Interruption of the power supply
. The operation of the washing machine is interrupted: the drain valve
opens and after a delay of approximately 3 minutes, the door is released.
If the door remains closed when the power supply is restablished, the wash cycle is resumed.
If the door is open, the wash cycle is cancelled.
On machines with pumped drain, the disconnection of the external automatic switch or the ON switch
do not allow the bath drain.
When a washing program is interrupted by electrical power failure, disconnecting the ON switch, or
activating the Emergency Stop, the door lock mechanism stops being controlled by the microprocessor and
the opening of the door is thermally delayed. In these circumstances, it is normal to have a washer delay or
inactive time of about 3 minutes.
Risk of entrapment
To avoid the risk that, while playing, a child gets entrapped inside a washer IT IS CAUTIONED THAT:
• After giving the start order, a safety delay of 30 seconds starts during which the drum rotation and the
entry of water operate at short impulses and the door remains released (see section 2.4)
• All the mechanisms that interrupt a program described in this section:
- stop the washer motor
- open the drain valve
- disconnect the door lock which can be opened after approximately 3 minutes.

GIRBAU EM040 Specifications

General

Brand	GIRBAU
Model	EM040
Category	Washer
Language	English