Cod. 429266
Rev. 01/0206
Description
8
1. DESCRIPTION
WASHER EXTRACTOR DESIGNED TO WASH OR TREAT FABRIC IN A WATER BATH.
1.1. CHARACTERISTICS
Construction characteristics
:
• HIGH SPEED MODELS (HS / EH). washers, capable of extracting with speeds above 350G
(280G in model HS-6008/EH020) without having to be bolted down. The design of its suspension
system: multi-directional springs and shock absorbers to cushion up to 95% of the vibrations produced
during the spin cycle.
• MEDIUM SPEED MODELS (MS / EM). Hard-mount construction. They have to be bolted down to the
floor.
• Stainless steel inner and outer drum. The openings in the
drum blades promote the uniform
distribution of bath water and improve the yield of the washer both during the wash and the rinse cycles.
• The drum rotation is produced by an asynchronous motor of alternating current controlled by inverter.
• Hot and cold water connections with a safety mechanism to prevent contaminating by back-flowing into
the general potable water system.
• Large capacity drain valve. (Option for pump drainage in models HS-6008/EH020).
• Water inlets and all product dispensers done using a common collector with an anti-siphon mechanism.
• Option for heating the bath using electric heaters or steam injection.
Functional characteristics:
• Operation control of the washer by microprocessor.
• Operation of the washer adaptable to the possibilities of the installation and the needs of the user.
• Washing programs: availability of eight pre-programmed programs. Each program allows for: three
phases of soak or pre-wash, wash phase with a maximum temperature of 90ºC (194ºF) and five rinse
phases with a final spin at high speed.
• Great versatility in individually modifying the content of each program. (More information about the
Programming Mode in the manual of Advanced Operation Instruction for the LOGI CONTROL on the
manufacturer website: www.girbau.com), (USA/CANADA www.cont-girbau.com
).
• Temperature control in the wash phase done by
hot and cold water mixer in
accordance with the programmed temperature and the activation of the heating system. Precision of +/-
2ºC (+/- 3.5ºF).
• Level control done with an electronic pressure transmitter.
•
communication via series between the washer microprocessor and the inverter control of the
motor. This communication takes advantage of all the features offered by inverter technology which
results in a significant energy savings and an optimal management of the spin cycle. This in turn implies
a significant reduction in noise, vibration and wear on the washer components.
• Multiple controls that assure the safe use of the washer.
1.2. EXPECTED USE OF THE WASHER
This machine has been made and designed for industrial washing or cleansing in a water bath, linen and
textile materials. Any other use will be considered contraindicated without the written authorization of the
manufacturer.
The washer should not be filled with a load which is much smaller or greater load than the nominal load.
Laundry should not be washed when loaded in bags. If necessary, load the machine to its nominal value.
It is not recommended to spin carpeting, canvas or waterproof fabrics.
To Next Page
Loading...
Need help?
General
