Cod. 429266
Rev. 01/0206
Operation
10
2.2 Loading the washing machine
Group the fabrics to be washed in homogeneous loads, trying to reach the nominal value of the load. Empty
all pockets, fasten buttons, close zippers and remove accessories that are not machine-washable. It is not
recommend mixing whites with other colours.
Open the door and load the machine. We recommend filling the drum to its nominal load. Do not overload the
machine; the door must be able to close easily.
Whilst the door is open, the display reads door, indicating that the door must be closed in order for the
program to begin.
2.3 Using the dispenser
Fill the compartments with the corresponding products, according to these symbols:
fig. 2 fig. 3
- Powdered detergent for pre-wash.
- Powdered detergent for wash.
∆ - Liquid bleach (chlorine, bleach...)
@ - Liquid softener / neutraliser.
For safety, close dispenser drawer or cover before starting the wash cycle.
SUDS CONTROL.
The mechanical action of front-loading washing machines improves the quality of the wash but
encourages creation of suds.
Remember that a suds bath always reduces the efficiency of your wash. ALWAYS USE
CONTROLLED SUDS DETERGENT.
Oversudsing causes an increase in the pressure inside the machine and decreases the efficiency of
the sealing systems.
Repeated washing with a large amount of suds considerably reduces the life of seals and bearings.
THIS CIRCUMSTANCE IS NOT COVERED BY THE MACHINE’S WARRANTY.
To Next Page
Loading...
Need help?
General
