Cod. 429266
Rev. 01/0206
22
Maintenance
VERY IMPORTANT
The protection of dispenser seal is necessary to prevent humidity and corrosion inside the machine
and the premature damage of the electrical and electronic circuits of machine control.
5.6. Cleaning the drain pump (Drain pump washers)
Only by the Authorised Technical Service
Required tools:
Disassembly of the lower front panel: Torx. T25 screwdriver.
• Before disassembling the lower front panel of the washing machine, disconnect and mechanically lock
the external switch, and close and mechanically lock the manual water inlet valves.
• Empty any residual water contained in the drain ducts, placing the corrugated rear tube horizontally on
the floor. The water will come out of the end.
• Disassemble the lower front panel. The draining pump is accessible.
• Turn the filter counter-clockwise and separate it from the pump body
fig. 6
• Clean the filter and the possible deposits from the inside of the pump body.
• Assemble the filter and the draining pump.
• Assemble the lower panel.
The bottom front cover is a stabilising element of the washer cabinet. Make sure that it is properly
mounted and fastened.
• Connect the external switch and open the manual water inlet valves.
• Begin a washing program and check that there are no water leaks
To Next Page
Loading...
Need help?
General
