GIRBAU EM055 User Manual

Cod. 429266
Rev. 01/0206
Advanced Mode / Troubleshooting
18
3. ADVANCED USE MODE. MOD mode.
There is an advanced use mode: the MOD mode. This mode includes five different menus through which
each user can personalise the operation of the washing machine.
Menus for advanced use mode:
MENU PURPOSE
Pro
Modification of the program contents
INFO
Information menu
Mod
Modification of operation parameters
Ncod
Modification of the access code
HOUR
Adjustment of the system time
Information on the menus, details and access mode: refer to the Advanced Operation Instructions for
LOGI CONTROL, at the manufacturer’s website: www.girbau.com
.
(USA/CANADA www.cont-girbau.com).
4. TROUBLESHOOTING
Some of the washing machine’s operating problems can be solved through the intervention of the user.
These problems are detailed below.
Should you have any questions, remember to consult the Authorised Technical Service.
4.1 What to do when…
....the wash cycle ends with the report: END/BAL
This report indicates that the final spin cycle is not possible because the load is unbalanced.
• Unload the machine and load it again.
• Begin the wash cycle and accelerate the program to the last phase.
• The washing machine will repeat the last spin cycle without refilling with water.
• If the problem persists, or occurs often, contact the Authorised Technical Service.
….the machine makes a strange noise during the spin cycle.
• Check the levelling of the machine. See Instruction Manual for Installation.
• Tighten the locking screws on the outside panels.
• If the problem persists, contact the Authorised Technical Service.
.... the door may have a leak
• Clean the door seal of any possible deposits or remains of cloth
.... there is water leaks inside the washer cabinet.
• Check the outlet draining pipe.
• Check the seals on the water inlet hoses; tighten the connection couplings.
• Check the condition of the door seal and if there are any ruptures.
• machines with pumped darain: Check the coupling of the filter and the draining pump (section 4.6)
• if the problem persists, seal all of the water inlets and contact the Authorised Technical Service.
….you have forgotten the access code for the advanced operating mode
• Contact the Authorised Technical Service.
.... the clock (option) stops working correctly
• Possible battery failure. Contact the Authorised Technical Service to have it replaced.

GIRBAU EM055 Specifications

General

Brand	GIRBAU
Model	EM055
Category	Washer
Language	English