Modification of operation parameters 34
Cod. 598144
Rev. 11/0717
10. MODIFICATION OF ACCESS CODE TO ADVANCED MODE. NCod menu
As described in Section 5.1 the access to ADVANCED MODE is restricted by an access code.
This code can be modified by the user if so desired.
It must always contain a combination of EIGHT keys.
Modifying of the access code
Access to the ADVANCED MODE. Section 5.1. The display shows Pro.
Press key 2 five times. In the display reports CASH, dEmo, InFO, Mod, Ncod are showed successively.
(In machines with extra options, press Key 2 six times. The displays shows CASH, EoPt, dEmo, InFO Mod and
Ncod successively.)
Press key 1 to access the set of a new code. All the information on the display will disappear.
Enter a combination of eight keys using the four central keys in the control panel.
The key pressed is displayed in the display with its corresponding numeric value.
At the end of the sequence the SURE report will be showed.
Confirm the new code with the 3 key.
If you don’t want to validate the code, press the STOP key.
Display will show NCod.
The keys 2 and 4 allow the access to other menus.
To exit the ADVANCED MODE press the STOP key.
To Next Page
Loading...
Need help?
General
