Troubleshooting
Problem Possible Cause Solution
There are leaks from the
handle.
The bonnet nut is loose.
The O-ring on the cartridge is
dirty or damaged.
Tighten the bonnet nut.
Clean or replace the O-ring.
The aerator leaks or has a
reduced water ow.
The aerator is dirty or
mis-tted.
The cartridge may be clogged.
Remove the aerator and check for debris.
Ensure the aerator is properly installed.
There are leaks from the
hose underneath the deck.
The connection between the
pull-out spray and pull-out
spray hose may be loose.
Tighten the connection between the pull-out
The hose does not retract. The weight is not installed in
the correct position.
The pull-out spray hose is
obstructed.
Reinstall or readjust the weight.
The water pressure is low. The quick connector may be
clogged with debris.
Turn off the water supply and disconnect the
quick connector from the outlet hose.
Disconnect the quick connector from the pull-
out spray hose and ush under running water.
Reattach the quick connector to the outlet
Test water ow. If water pressure is still low
then replace the quick connector.
There is no hot or cold
water.
The hot or cold water supply
lines may be kinked or
twisted.
NOTE: Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
Remove the cartridge and check for debris.
Care and Cleaning
To clean, wipe down with a damp cloth and towel dry.
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
Check under the sink to ensure the pull-
out spray hose is not obstructed.
Ensure hot and cold water supply lines are
not kinked or twisted. Reinstall the supply
line if necessary.
hose.
spray and pull-out spray hose.
9 HOMEDEPOT.COM/GLACIERBAY
To Next Page
Loading...
Need help?
General
