Glamox ITNSL-01T User Manual

FAULT
CONTROL
Broken light alarm presentation and alarm accepting
Navigation and signal lights controller with built-in fault control continuously monitors status of navigation
and signal lights.
FAULT
CONTROL
In case of failure detection (1) it alarms operator (2).
Fault detection alarm
1.Alarm symbol, accept push button occurs and buzzer sounds.
FAULT
CONTROL
1
2
2
1
Alarm
2. Tap on accept push button to silence buzzer
3. Tap on accept push button to stop blinking
Light indication will have fault indication until it is turned off or it is repaired.
IMPORTANT!!!
Power supply will remain present on terminals/light.
After alarm is accepted (pls. check above section).
3
Fault in case of double navigation lights
In case double navigation lights are used, fault detection on main light (1) will automatically switch over to
spare light (2) (and vice versa).
1
2
3. Text SPARE IN USE and turn on light symbol occurs
NOTE!!!
Once light alarm is confirmed it will show as above (SPARE IN USE and
“turn on”). There will be no indication that main light has failed. In case of
turning on main light failure alarm will be repeated.
26

Glamox ITNSL-01T Specifications

General

Brand	Glamox
Model	ITNSL-01T
Category	Controller
Language	English