For maximum protectlon specify an
AC Acron air filter element.
Fuel Filter
Replace filter element every 12
months or 12,000 miles. whichever
occurs first.
Specify AC at replacement time.
Distributor Cam Lubricator
4 and 6 Cylinder Engine-Rotate cam
lubricator 180° at 12,000 mile inter-
vals-Replace at 24,000 mile intervals.
8 Cylinder Engine-Change cam lu-
bricator end for end at 12,000 mile in-
tervals-Replace at 24,000 mile
intervals.
Rear Axle
Siandard-Every 6,000 Miles - Check
and keep filled to level of filler plug
hole with SAE 80 or SAE 80-90 Multi-
purpose Gear Lubricant meeting re-
quirements of U.S. Ordnance Spec.
MIL-L-2105-B.
Positraction-Same as standard axle
but use only the special positraction
lubricant available from your Chev-
rolet Dealer.
Transmisslon
3-Speed and 4-Speed-Every 6,000
miles-Check at operating tempera-
ture and fill as necessary to level of
filler plug hole with SAE 80 or SAE
80-90 Multi-purpose Gear Lubricant
meeting requirements of U.S. Ord-
nance Spec MIL-L-2105-B.
Transmission Shift and Backdrive
Linkage (Manual and Automatic)-
Every 6,000 miles or 4 months lubri-
cate shift linkage and on manual
transmission Hoor controls lever con-
tacting faces with water resistant EP
chassis lubricant which meets GM
Specification 6031M.
If vehicle is equipped with a 6 cyl-
inder engine and Powerglide trans-
mission, lubricate the throttle valve
inner lever, outer lever and sleeve
(linkage) (at inlet manifold attach-
ment) on their respective contacting
surfaces wth Water resistant EP chas-
sis lubricant which meets GM Specifi-
cation GM 6031M. Operate linkage to
evenly distribute lubricant.
Clutch Cross-Shaft
Every 36,000 miles or sooner if nec-
essary-Remove the plug, install a lu-
brication fitting and lubricate with
Water resistant EP Chassis Lubricant
which meets GM SpeciHcation G031M.
Powerglide Turbo Hydra-
Matic 350 and Torque Drive
Every 6000 miles-Check Huid level
on dipstick.
Transmission at Operating Tempera-
ture-With the transmission hot (after
vehicle_has been driven at least 15
miles), the fluid level should be be-
tween the "FULL" mark and % inch
below FULL. The vehicle should be
level with the engine idling and the
transmission in PARK.
Transmission at Room Temperature
(80°F)-If the vehicle has not been
driven sufficiently to bring the trans-
mission up to operating temperature,
the fluid level should be checked as
follows:
1. Apply the parking brake, put the
selector lever in PARK, and start
the engine. Note: Do Not Race the
Engine. Move the selector lever
through each range.
2. Immediately check the fluid level
with the selector lever in the
PARK position. The engine should
be running at a slow idle and the
ee
To Next Page
Loading...
Need help?
General
