golmar CODEPROX-N User Manual

7
CODEPROX-N
www.golmar-seguridad.es
Deletion of cards by approaching the card to be deleted.
Enter the ID corresponding to the user to be deleted.
Example: * 987654 # 2 APPROACH CARD
Example: * 987654 # 2 1 #
9.1.7.CARD DELETION
9.1.8.DELETING CARDS OR PIN (specic ID)
Enter administrator mode
*
MASTER CODE
#
Enter administrator mode
*
MASTER CODE
#
2
APPROACH CARD
2
USER ID
(0-989)
#
10.3. RELAY SETTINGS
Example: * 987654 # 4 15 #
Example: * 987654 # 4 0 #
Enter administrator mode
*
MASTER CODE
#
Enter administrator mode
*
MASTER CODE
#
4
1-99
#
4
0
#
10.3.1.PULSE MODE
10.3.2.LATCHING MODE
e pulse can be active from 1 to 99 seconds. In the example, the value 15 has been entered, so it would be active for 15 seconds.
Default value: 5 seconds.
e relay switches to ON/OFF mode.
10.OTHER SETTINGS
10.1. IDENTIFICATION MODE
Example: * 987654 # 30 #
Example: * 987654 # 32 #
Enter administrator mode
*
MASTER CODE
#
Enter administrator mode
*
MASTER CODE
#
30
#
32
#
10.1.1.IDENTIFICATION BY CARD OR PIN (default value)
10.1.2.IDENTIFICATION BY CARD ONLY
10.2. ALARM SETTINGS (TAMPER)
Example: * 987654 # 52 #
Enter administrator mode
*
MASTER CODE
#
5(0-3)
#
10.2.1.ACTIVATE TAMPER
e tamper alarm activation time is from 0 to 3 minutes. In the example, the value 52 has been entered, so it would be active for 2 minutes.
Default value: 51 (1 minute).
It is possible to change the PIN, but it is not necessary to access programming. When the reader is in standby mode, enter:
Example: * 1 # 4543 # 6688 # 6688 #
9.1.9.MODIFY PIN
*
USER ID
#
PIN TO MODIFY
#
NEW PIN
#
NEW PIN
#

golmar CODEPROX-N Specifications

General

Brand	golmar
Model	CODEPROX-N
Category	IP Access Controllers
Language	English