12
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received,including interference that may cause undesired operation.
Please Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
The Federal communications Commission warns that changes or modifications to the
unit not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
European Notice
Products with the CE marking comply with both the EMC Directive (2014/30/EU), (93/68/
EEC), R&TTE Directive (2014/53/EU) and the Low Voltage Directive (2014/35/EU) issued by
the Commission of the European Community.
FCC Compliance Statement
Caution: To comply with the limits for an FCC Class B computing device,
always use the signal cord and power cord supplied with this unit.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
