Technical Specifications
98 3A2776K
Technical Specifications
XM PFP
US Metric
Ratio Tolerance Range (before alarm) +/- 5%
Maximum Flow Rate (measured with oil) 3 gallons per minute 13.6 liters per minute
Fluid Viscosity Range
Handles mastic materials which are loaded into heated tanks with
ram-fed priming piston pumps
Air Inlet 1 in. npt(f)
Fluid Inlets Pail (Feed Pumps)
Maximum Fluid Working Pressure for
A and B Materials
6000 psi 41 MPa, 414 bar
Maximum Fluid Working Pressure for
Flushing Fluid
4500 psi 31 MPa, 310 bar
Maximum Fluid Working Pressure for
Heating Fluid
100 psi 0.7 MPa, 7 bar
Maximum Fluid Temperature 160°F 70°C
System Inlet Supplied Air Pressure Range 80-150 psi 0.5-1.0 MPa, 5.5-10.3 bar
Maximum Main Pump Air Pressure 100 psi 0.7 MPa, 7 bar
Maximum Feed Pump Air Pressure 65 psi 0.45 MPa, 4.5 bar
Maximum Tank Air Pressure 90 psi 0.6 MPa, 6 bar
Air Filtration
40 micron main filter, 5 micron control air filter, 3 micron purge
controller filter (Hazardous Location only)
Ambient Operating Temperature Range 32 to 130 °F 0 to 54 °C
Ambient Storage Temperature Range 30 to 160 °F -1 to 71 °C
Environmental Conditions Rating Altitude up to 13,123 ft Altitude up to 4000 m
System Weight (empty, no fluid) 2175 lb 987 kg
Air Filtration
40 micron main filter, 5 micron control air filter, 3 micron purge
controller filter (Hazardous Location only)
Mix Ratio Range
262869, 262943 1.5:1 to 4:1
24W626, 262945 1:1 to 1.5:1
Air Consumption
Minimum 100 scfm 2.8 meter^3/min
Maximum
250 scfm
7.1 meter
3
/min
Typical Application
125-175 scfm
3.5-5.0 meter
3
/min
Power Requirements
Voltage (can be set with jumpers)
Option 1: 200-240 VAC, 3 phase DELTA (3 wire plus ground)
Option 2: 350-415 VAC, 3 phase WYE (4 wire including neutral plus
ground)
Wattage
18,800 watts (non-hazardous location)
18,900 watts (hazardous location)
22,900 watts (with hazardous location flush water heater)
23,400 watts (with optional non-hazardous flush water heater)
Amps
200-240 VAC, 3-phase models DELTA: 63 Amps per phase full load
350-415 VAC, 3-phase models WYE: 40 Amps per phase full load
To Next Page
Loading...
Need help?
General
