Grandstream Networks GDS370 Series User Manual

Cut into the plastic sheath of your Ethernet cable, then Unwind and pair as shown below.
Use the TIA/EIA 568-B standard, which defines pin-outs for using Unshielded Twisted Pair cable and RJ-45 connectors for
Ethernet connectivity.
Figure 6: Connection Example
Connect each wire of the cable to its associate on the Back Cover of the GDS370x to power the unit using PoE.
Power GDS370x using PSU
To power the unit using PSU, use a multimeter to detect the polarity of your Power Supply, then connect GND to the
negative pole and 12V to the positive pole of the PSU.
Figure 7: Powering the GDS370x
GETTING TO KNOW GDS370x
The GDS370x has an embedded Web server to respond to HTTP/HTTPS GET/POST requests. Embedded HTML pages allow
users to configure the GDS370x through all available Web browsers in the internet.
Connecting GDS370x to Network with DHCP Server
The GDS370x by default has a DHCP client enabled, it will automatically get IP address from DHCP server.
Note
If the user doesn’t have PoE switch, there is no need to connect the Blue and Brown wires to the GDS370x since these wires are
used to power the unit via Ethernet.

Grandstream Networks GDS370 Series Specifications

General

Brand	Grandstream Networks
Model	GDS370 Series
Category	Intercom System
Language	English