Enable Direct
IP Call
Accepts peer-to-peer IP call (over UDP only) without SIP server.
Default is “Enabled”.
Enable two-
way SIP
Calling
Allows the user to enable/disable the alarm sound during a SIP call triggered by doorbell pressing.
Allow Reset
Via SIP NOTIFY
Allows to factory reset the devices directly through SIP Notify.
If “Allow Reset Via SIP NOTIFY” is “check”, then once the GDS3705 receives the SIP NOTIFY from the SIP
server with Event: reset, the GDS3705 will perform a factory reset after authentication.
This authentication can be either with:
The admin password if no SIP account is configured on the GDS370x.
The SIP User ID and Password credentials of the SIP account if configured on the GDS370x.
Default is unchecked (disabled).
Table 16: Phone Settings
Account [1-4] White List
This page allows users to configure the white list per account, which is a phone number or extension list that can call the
GDS370x. (The call will be automatically answered when calling from a phone set on the white list, and all other inbound calls
will be blocked), the user can configure up to 30 white phone numbers per SIP account.
Moreover, besides numbers associated to active cards, and numbers on the “Number Called When Door Bell Pressed” setting,
all whitelisted numbers can open door remotely by using the respective PIN code ( Can be configured for the GDS3705 Model
only)
Figure 65: White List Page
The table below gives a brief overview of the options:
Enable White Number List Enables the White List feature.
Phone Number 1 -200 Adds a new phone number to the white list.
Table 17: White List
Audio Settings
The audio settings allow users to configure the audio codecs and Volume related settings.
To Next Page
Loading...
Need help?
General
