Video connections
AV in/out Port
RCA Connector: Gelb: Video, Weiß: Audio
Links, Rot: Audio Rechts
Video recording
Connect AV cable to AV out port on right side of headset. Con-
nect recording device to cables and set up as per manufacturer
directions.
Note: Cables pins are not all the same (see above chart), be sure
to connect to headset using the included cable.
Using an external receiver
Use the AV cable to connect headset to the RCA AV port of
external devices.
To share the base station power supply with your goggles, pick
up a 3m Dominator AV cable accessory from your retailer. Note;
internal receiver must be shut off to properly display external AV.
Charging the battery
CAUTION
General notes on safety and handling LiPo batteries
• NEVER leave a LiPo battery unattended when in charge.
Charge the batteries only in rooms where a smoke detector is
installed.
• ALWAYS control the battery and the charger during the entire
charge process.
• ALWAYS charge the batteries on a non-flammable surface.
• ALWAYS keep an extinguisher suitable for Lithium “Class type
D” when charging LiPo batteries.
• NEVER charge LiPo batteries at a higher rate than 1C („C“
means the indicated capacity of the battery).
• NEVER charge the LiPo battery with a charger which does not
detect the full charge state of the battery. Over-warming or inflat-
ing of the LiPo cells indicates a problem and the LiPo battery
should be disconnected from the charger and brought to a fire-
safe place.
• ALWAYS interrupt the charge or discharge process of a LiPo
battery if you detect smoke or if the battery slowly inflates. Let
To Next Page
Loading...
Need help?
General