EN - 22
CHECK TIRE PRESSURE
See Specifications on page 30 for
recommended tire pressure.
CHECK FASTENERS
Check for loose or missing hardware.
LUBRICATE UNIT
Models 915255, 915256, 915257
See Figure 28.
1. Place unit in service position. See Model
915278 on page 20.
2. Apply grease to seat tracks through slots
under seat plate.
3. Return seat to operating position and
slide seat back and forth to spread
grease along tracks.
CHECK MOWER BLADES
Check blades for wear or damage. Replace
or sharpen as needed.
See Figure 29.
WARNING: AVOID INJURY.
Explosive separation of tire
and rim parts is possible.
• DO NOT inflate tires above
the recommended pressure.
• DO NOT inflate tires with a
compressor; use a hand
pump.
• DO NOT stand in front of
tire assembly when
inflating. Use a clip-on
chuck and extension hose
long enough to allow you to
stand to one side.
CAUTION: AVOID INJURY. Use
sturdy gloves or padding to
protect hands when working with
mower blades.
Rotation of one blade rotates the
other blades.
CAUTION: DO NOT sharpen
blades while attached to unit.
CAUTION: Unbalanced blades
cause excessive vibration and
eventual damage to unit.
Balance blades before
reinstalling on unit.
NEVER weld or straighten
blades.
Figure 29
1. Cutting Edge
2. Square Corner
3. Air Lift Erosion
4. Air Lift
2
1
1
3
4
DISCARD if more than
1.3 cm (1/2")
DO NOT sharpen to this
pattern.
Sharpen to this pattern.
To Next Page
Loading...
Need help?
General
