EN - 26
Install PTO Belt
See Figures 32 and 33.
1. Install PTO belt in the following order:
a. Around split pulleys.
b. Around idler pulleys at deck center.
2. Reinstall idler spring hook around anchor
bolt to apply tension to belt. See
Figure 34.
IMPORTANT: Make sure belt has tension and
is aligned in all pulleys.
3. Reinstall belt covers and tighten wing
knobs.
REPLACE TRANSAXLE DRIVE
BELT
Remove Transaxle Drive Belt
1. Place unit in service position. See
Service Position on page 16.
2. Remove PTO belt from clutch. See
Remove PTO Belt on page 25.
3. Under unit, slowly remove spring hook
from anchor bolt to release transaxle idler
tension. See Figure 35.
1. Idler Pulley
2. Split Pulley
Model 991144
1
2
Figure 32
1. Idler Pulley
2. Split Pulley
Figure 31
Figure 33
Model 991145
1
2
CAUTION: Use care when re-
leasing idler spring tension. Keep
body parts away from idlers
when performing this operation.
To Next Page
Loading...
Need help?
General
