Button
UP
Function button
● When selecting the function by function button, if the unit is not turned off and it hasn’t get the remote control signal within 2min,
press function button and then it will circulate from the previous set function. 2min later or when turning off the unit or the unit has get
the remote control signal, press the function button and it will circulate from the rst icon.
● Clean function: This function is not available under on status. Under off status, press “function” button until clean icon is ashing.
Press ▼ or ▲ button to enter into clean function. At this time, the case starts rotating until the lter is rotated to he front side of air
conditioner.
Press button to turn off the clean function and the unit will exit from the clean status. The main body will rotate to the reset position.
After entering into clean function:
A. When pressing ON/OFF button, it will exit from the clean function and the unit will start operation;
B. When pressing function button, if clean icon is ashing, it indicates clean function can be canceled. The case will rotate to the
reset position and the complete unit stays under standby status.
● Under on status, when each pressing of function button, it will set and change in the sequence of X-fan, timer, purify (not available
for this model), set and room temperature. When certain characters are ashing, it indicates this function can be set. Press ▼ or
▲ button to set it. It there’s no operation within 5s after setting, the setting is conrmed. Or press function button can also conrm
the setting.
● Under X-fan status, press function button to turn off the unit directly. Under off status and X-fan is not set, when each pressing
function button, it can switch between timer and clean setting. When certain characters are ashing, it indicates this function can
be set.● Press ▼ or ▲ button to set it. It there’s no operation within 5s after setting, the setting is conrmed. Or press function
button can also conrm the setting.
Mode button
● Press this button continuously and the mode will change circularly among “cool →dry→fan→heat (not available for this cooling
only air conditioner)→auto”. (Note: Cooling only unit won’t accept heating operation signal. For cooling only unit, pressing MODE
button under FAN mode will skip heating mode and enter cooling mode.)
▼ and ▲ buttons
● After pressing ▼ or ▲ button for once, the set temperature will increase or decrease 1
℃
. The temperature range is 16
℃
~30
℃
.
This button is invalid under auto mode. Timer setting can be adjusted within the range of 0~24h.
● When pressing ▼ and ▲ buttons simultaneously for consecutive 3s, the air con- ditioner will display “LC”, which indicates buttons
are locked. It’s invalid when pressing any buttons under on status or pressing ON/OFF button and function button under off status.
When press ▼ and ▲ buttons simultaneously for con- secutive 3s again, lock will be released.
1.ON/OFF button
● This button is used for turning on or turning off the uit.
(Note: Under X-fan operation, pressure ON/OFF button will turn on the unit directly.)
2.Speed button
Press this button and the fan speed will be selected and displayed according to below method:
To Next Page
Loading...
Need help?
General
