OM-CC-G and C/2-G
12
9. Select Fahrenheit or Celsius Temperatures.
The Convection Combo™ is delivered with the
Fahrenheit scale as default. To change the
temperature scale, hold the 5 key in, and press
ON. The Time/Status display will show dEG°F or
dEG°C. Press the 5 key to change from one to
the other. Press START to accept the change.
10. To Test Steamer Mode Operation, turn on the
unit. (For operating procedure details, see the
Operation section of this manual.) Clear time
from the time display. Close the door and press
the STEAM touch pad. (If the HOT light is on,
see Fast Cool in the Operation section.)
The WAIT light will stay on while the steam
generator fills with and heats the water. It should
turn off within three minutes, and the READY
light should come on. This indicates that the
water is at its standby temperature. The timer
only controls operations in the Steamer Mode.
Enter a time and press START. (“Time” is set in
minutes and hours only. Seconds are not
displayed).
Examples: 2 minutes = 00:02
(Just press 2).
1 hour and 30 minutes = 01:30
(Press 1, 3, and 0, or press 9 and 0
the timer will change to 1:30)
The colon [:] between the numbers will blink and
the generator will begin to produce steam. Time
only counts down when the READY light is lit.
NOTE: You cannot change modes if the timer is
running.
WARNING
WHEN YOU OPEN THE DOOR, STAY AWAY
FROM STEAM COMING OUT OF THE UNIT.
THE STEAM CAN CAUSE BURNS.
11. Test Combo Mode Operation, turn on the
power and clear any time from the Time/Status
display. Press the COMBO touch pad. Set the
COOK temperature to 350
o
F (175
o
C). The WAIT
light will come on. It will remain on while (1) the
steam generator fills with water and heats it to its
standby temperature and (2) the air heater raises
the air temperature to 350
o
F. Both actions
should be completed in five to eight minutes,
starting with a cold unit. When the set
temperature is attained, the WAIT light will go
off, and the READY light will come on. NOTE:
The timer does not control the oven in either the
Combo or Oven Modes.
12. Test Oven Mode Operation, turn on the power
and clear the Time/Status display. Press the
OVEN touch pad. Set the cook temperature to
350
o
F (175
o
C). The WAIT light will come on.
Within eight minutes of a cold start, the WAIT
light should go out and the READY light come
on. When that happens, turn the COOK setting
down to 320
o
F (160
o
C). The HOT light will come
on. Heat-up times may vary slightly with voltage
or water pressure differences.
13. To shut down the unit, switch off the power. The
pilot burner may also be turned off to conserve
energy.
14. If the Convection Combo™ works as described,
the unit is functioning correctly and is ready for
use.
To Next Page
Loading...
Need help?
General
