ENGLISH
86
11 Press »
« (red) to start searching.
Notes:
7
When updating via the same satellites a
security query is displayed at the start of a
search.
7
If the previously stored channels should
be retained in the channel list and the new
channels found be added to it, then press
»
« (green).
7
If »
« (red) is pressed, the saved channels
will be deleted from the current channel list.
– The »Digital Searching« menu appears,
and the scan for TV channels begins.
– The search is complete as soon as the
message »Search is completed!« appears.
Note:
7
The search can be aborted with »EXIT«.
12 Switch to the Channel Editor with »
«
(yellow);
or
press »EXIT« to end the setting.
Antenna settings for DiSEqC
1.0/1.1 and searching digital
channels from a satellite auto-
matically
Note:
7
The following description about the LNB set-
tings premise a substantial expertise about
the satellite systems. Ask your specialist
dealer.
1 Open the menu with »MENU«.
2 Select menu item »Settings« with »
V
«, »
Λ
«,
»
<
« or »
>
« and press »OK« to confirm.
3 Select the menu item »Source« with »
>
« or
»
<
« and press »
V
« to confirm.
– »Source« menu is active.
4 Select the line »Automatic Channel Search«
with »
V
« or »
Λ
« and press »OK« to
confirm.
5 Select the option »Satellite (DVB-S/S2)«
with »
V
« or »
Λ
« and press »OK« to
confirm.
6 Select the line »Antenna Settings« with »
V
«
or »
Λ
« and press »OK« to confirm.
– The »Antenna Settings« menu is dis-
played.
7 Select and set the required option for the
antenna settings with »
V
« or »
Λ
«:
Satellite
Press »OK« then select the required satel-
lite with »
V
« or »
Λ
« and press »OK« to
confirm.
LNB Type
Press »OK« then select the required LNB
Type with »
<
« or »
>
«, enter the required
data and confirm with »
« (green).
LNB Power
Set the LNB power to »Off«, »13/18V« or
»14/19V« depending on the LNB type by
using »
<
« or »
>
«.
LNB selection
See DISEqC mode.
SETTING FURTHER CHANNELS
-----------------------------------------------------
To Next Page
Loading...
Need help?
General