To Next Page

To Previous Page

More settings

This secon describes the features and sengs of the Roku TV that were not covered in the other parts of this guide.

Changing network settings

If needed, you can change your network sengs at any me. For example, if you change the name of your wireless

network (its SSID) or its password, you will need to change your TV’s sengs so that it can connue to connect. Also, if

you decided not to connect to the Internet in “Guided setup” on page 18 , you can use Network sengs to connect

at a later me.

To change network sengs, from the Home screen menu, navigate to Sengs > Network, and then press . At this

point, you can choose the following opons:

• Update connecon – Press OK to start the update process. The TV uses your current wireless network

name and password to reconrm the Wi-Fi connecon, the local network connecon, and the Internet

connecon.

• Set up new Wi-Fi connecon – Press OK to start a scan for wireless networks. The TV scans for the wireless

networks within range and displays the rst few it nds in order, with the strongest signals rst. In addion

to your own wireless signal, the TV might pick up signals from your neighbors. Now you can do one of the

following:

Select your network name – Select the name of your network and then enter your wireless

password if requested.

Scan again – If you don’t see your wireless network name in the list, select Scan again to list all

networks in range. The rst scan listed only the rst few, strongest wireless signals. The second

scan somemes results in a longer list. If you sll don’t see your network name, you might need

to adjust the locaon of the wireless router or the TV, turn on your router, or make other changes.

When everything is ready, select Scan again to repeat the network scan.

Note:

Highlighng

Scan Again

displays an informaonal panel with the unique media access control

(MAC) address of your Roku TV. You will need the MAC address if your wireless router is congured

to use MAC address ltering.

o Private network – If your wireless network name is hidden, it won’t appear in the list. Select

Private network to display an on-screen keyboard, and use it to enter your network name. Unless

you changed the factory-set network name, you can nd the name (also called SSID) on a label the

router.

Tip

: Wireless networks that are password-protected display a “padlock” icon adjacent to the name.

Haier 43E4500R User Manual

Questions and Answers: