4-5 Remove the power module 4-8 Remove the keypad control
_1_ Remove the four screw indicated on the
figure above by the red line.
_2_ Then remove the power module
4-6 Remove the Main board
[] Remove the two screw indicated on the figure
above by blue line.
_Then remove the keypad module.
_1_ Remove the eight screw indicated on the
figure above by the red line.
_2_Remove the Main board
4-7 Remove the remote control
Remove the one screw, take out the remote
control board
14
To Next Page
Loading...
Need help?
General
