4-5 Usage of the drain hose
The drainage shall be smooth with the drain hose.
1.put the drain hose up to suitable position.
2.Do not step on or press the drain hose.
<1.2m
Figure 3
Figure 2
Figure 1
1. Insert a new flat washer into each end of the inlet hoses. Firmly seat
the washers in the coupling. ( As figure 1)
2. ttach the water inlethoses to the water faucet . Using
pliers,tighten the coupling . ( As figure 2)
NOTE: Do not overtighten. Damage to the valves can result.
Respectively a
5. Check for leaks
(1). Swing the water inlet hose gently to confirm if it's suitable.
(2). Turn on the water faucets and check for leaks. A small amount of
water might enter the washers. You will drain this later.
3. Run water through the faucets and inlet hoses, into a bucket or laundry
tub, to get rid of particles in the water lines that might clog the inlet
valves screens.
4. Attach the hose connected with the water faucet to the water valve.
( As figure 3)
NOTE: Do not overtighten. Damage to the valves can result.
Do not take off the water absorption cushion. Please check if the cushion
is dropped or damaged before each usage. If it happens please contact
our after-sale department immediately.
Water absorption cushion
Figure 4
(As Figure 4)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
