Operation
□ Install a 12V MN21/A23 battery (P) (included) into the remote
control (O). To prevent damage to the remote control (O),
remove the battery if not used for long periods.
REMOTE CONTROL OPERATING INSTRUCTIONS
REMOTE CONTROL OPERATING INSTRUCTIONS
INSTALLING THE REMOTE CONTROL HOLDER
INSTALLING THE REMOTE CONTROL HOLDER
Q
EE
R
16
O
P
□ Restore power to the ceiling fan, and test for proper operation.
"HI , MED, LOW" buttons: These three buttons are used to set the
fan speed as follows: LOW = Low speed, MED = Medium speed,
and HI = High speed.
"OFF" button: This button turns the fan off.
The " " button turns the light ON or OFF and also controls the
brightness setting. Press and release the button to turn the light
ON or OFF. Press and hold the button to set the desired brightness.
The light button has an auto-resume; it will stay at the same
brightness as the last time it was turned off.
□ Remove the two remote control holder plugs (R) from the
remote control holder (Q). Note that the plugs have unique
tabs that allow them to fit only in one hole.
□ Attach the remote control holder (Q) with the two remote
control holder mounting screws (EE).
□ Replace the two remote control holder plugs (R) each into its
own hole.
To Next Page
Loading...
Need help?
General
