Hantek HDG2022B User Manual

SCPI Programming Reference
HDG2000 Series Arbitrary Waveform Generator 91
SYSTem:BEEPer
Issues a single beep
Parameter
Typical Return
none
none
SYSTem:BEEPer
This command overrides the current beeper state (the SYSTem:BEEPer:STATe ). This means
that you can issue asingle beep even if the beeper is turned off.
SYSTem:BEEPer:STATe ON|OFF
Disables or enables the beeper.
Parameter
Typical Return
ON|OFF, on ON
ON, or OFF
Enable beeper: SYSTem:BEEPer:STATe ON
Turning off the beeper does not disable the front-panel key click.
A beep is always emitted (even with beep state OFF) when SYSTem:BEEPer is sent.
This setting is non-volatile; it will not be changed by power cycling or *RST.
SYSTem:COMMunicate:LAN:GATEway <address>
SYSTem:COMMunicate:LAN:GATEway?
Set gateway.
Parameter
Typical Return
0.0.0.0 to 223.255.255.255(127.x.x.x is
not included)
nnn.nnn.nnn.nnn
Set gateway to 192.168.1.1: SYSTem:COMMunicate:LAN:GATEway 192.168.1.1
SYSTem:COMMunicate:LAN:IPADdress <ip_addr>
SYSTem:COMMunicate:LAN:IPADdress?
Set IPaddress
Parameter
Typical Return
0.0.0.0 to 223.255.255.255(127.x.x.x is
not included)
IP: nnn.nnn.nnn.nn
Set IP to 192.168.1.118: SYSTem:COMMunicate:LAN:IPADdres 192.168.1.118
SYSTem:COMMunicate:LAN:MAC?
Find MAC address
SYSTem:COMMunicate:LAN:SMASk <mask>
SYSTem:COMMunicate:LAN:SMASk?

Hantek HDG2022B Specifications

General

Brand	Hantek
Model	HDG2022B
Category	Inverter
Language	English