Basic Operation
HDG2000 Series Arbitrary Waveform Generator 24
1. Browse files and dirs
2. Create or delete files and dirs
3. Create a new dirs folder
4. Open files identified by the device
Brower files and dirs:
1. Choose a storage media. Press F1 to choose media area in the window as focus area, rotate
the knob button and press enter button to change the current media.
2. Choose the file. Press F1 to choose file area in the window as focus area, change the current
file by rotating the knob button.
Delete files:
1. Choose the file. Then press F5 button to delete it.
2. After delete all files in a dir, choose the dir and press F5 to delete it.
Create dirs floder:
Press F4 to create a new dir under parent dir.
Open files:
1. Choose the file.
2. Press Enter button to recall the file, if the file can be recognized, it will be opened automatically.
Otherwise, nothing happens.
Save and load in internal flash, external USB or SD card:
1.Click “Utility->SysStatus->Save” to save system status as .hsf file.
2.Click “Utility->SysStatus->Recall” to recall saved system status from .hsf file.
3.In arb menu, click “Type->User->Recall” or click “Editor->File->Open” to recall arb waveform
data from .hwf file.
4.In arb menu, click “Editor->File->Save” to save arb waveform data which is edited by HDG2000
to .hwf file. Especially, the size of the data file must be less than 2M. When user uses software
to edit and download arb wavefrom to HDG2000, the data can not be saved by HDG2000
again.
2.4 Remote Control
The device can communicate with PC by USB port.
The software on the PC can create more waves data and carry out the operation for waveform
signal at the same time.
To Next Page
Loading...
Need help?
General
