Hantek HDG2032B User Manual

SCPI Programming Reference
HDG2000 Series Arbitrary Waveform Generator 70
to the starting burst phase of the waveform.
The following table shows which modes are associated with which burst features.
SOURce<n>:BURSt:GATE:POLarity NORMal|INVerted
SOURce<n>:BURSt:GATE:POLarity?
Selects NORMal or INVerted logic levels on the front-panel TRIG connector for an externally gated
burst.
Parameter
Typical Return
NORMal|INVerted, default NORMal
NORMal, or INVerted
Select INVerted for an externally gated burst: SOURce1:BURSt:GATE:POLarity INVerted
SOURce<n>:BURSt:MODE TRIGgered|GATed|INFinity
SOURce<n>:BURSt:MODE?
Selects the burst mode.
Parameter
Typical Return
TRIGgered|GATed|INFinity, default TRIGgered
TRIGgered, GATed, or INFinity
Set gated burst mode: SOURce<n>:BURSt:MODE GATed
TRIGgered: the instrument outputs a waveform for a number of cycles (burst count) each time a
trigger is received from the trigger source (SOURce<n>:BURSt:TRIGger:SOURce).
In GATed burst mode, the output waveform is on or off, based on the signal at the rear-panel
TRIG connector. Select this signal's polarity using SOURce<n>:BURSt:TRIGger:SLOPe
POSitive|NEGative. When the gate signal is true, the instrument outputs a continuous
waveform.
GATed: burst count, burst period, and trigger source are ignored (these are used for the
triggered burst mode only). I
SOURce<n>:BURSt:NCYCles <cycles>|MINimum|MAXimum
SOURce<n>:BURSt:NCYCles? [MINimum|MAXimum]
Sets the number of cycles to be output per burst (triggered burst mode only).
Parameter
Typical Return
1 to 1 000 000(External or manual trigger);
1 to 500 000(Internal), only for N cycle;
Default 1
+5.000000000000000E+00
Return number of cycles per burst: SOURce1:BURSt:NCYCles 5
SOURce<n>:BURSt ON|OFF
SOURce<n>:BURSt?
Enables or disables burst mode.

Hantek HDG2032B Specifications

General

Brand	Hantek
Model	HDG2032B
Category	Inverter
Language	English