Harman® • Accentra Owner’s Manual_R40 • 2002 -___ • 11/1510 3-90-08326c
B. Fire Characteristics
Aproperlyadjustedrehasamediumactiveamepattern
that extends out of the burn pot approximately 6 inches
(152mm).
C. Feed Limit Adjustment Instructions
TheFeed Limit control isfactoryset at #4, and shouldbe
adequateformostfuels.
However,iftheflameheightistoohighortoolow,youwill
needtoadjustthefeedrate. Wait until theappliancehasbeen
burningfor15minutesbeforemakingyouradjustmentsand
a
llow15minutesfortheFeedLimittotakeeffect.
A. Starting Your First Fire
1. A room sensor is required for proper operation of this
appliance in “Room Temp” mode. At this time, ll the
hopper with pellets, insure the control is set to “OFF”.
Figure4.2.Plugthepowercordintoaproperlygrounded,
nearbyoutlet.
2. Oncepowerispresent,theunititwillrunthroughaquick
diagnosticstesttoinsurethecontrolisoperatingproperly.
Thisisnormal.
3. Foryourrstreitmaybenecessarytopurgetheauger
systembyputtingthefeedLimitknobto“Test”priorto
startingtheunit.Figure4.3.Thisinsuresthatplentyof
fuelenterstheburnpotforproperignition.
4. Flip toggle switch to desired mode “auto or Disabled”.
Figure4.4.SetFeedLimitknobtodesiredsettingandturn
modedialto“RoomTemp”or“ConstantBurn”Figure4.5.
Note:Feedrateof#4isagoodstartingpoint.Adjustments
madeneedtobemadedependingonfuelqualityand/or
heatoutputdesired.
5.
Thefuelfeedsystemandtheignitershould
now
beon.
6. Oncetheappliancehasignited,letitburnforapproximately
7-10 minutes.After this time the unit should begin to
operateperthesettingsatthecontrol.
Figure 4.5
Odorsandvaporsreleasedduringinitialoperation.
• Curingofhightemperaturepaint.
• Openwindowsforaircirculation.
Odorsmaybeirritatingtosensitiveindividuals.
Figure 4.2 Figure 4.3
Figure 4.4
4
Operating Instructions
CAUTION